root后的启动代码如下,供参考:

root@sabresd_6dq:/ # EXT4-fs (mmcblk0p7): re-mounted. Opts: (null)

ERROR: v4l2 capture: slave not found!

ERROR: v4l2 capture: slave not found!

ERROR: v4l2 capture: slave not found!

ERROR: v4l2 capture: slave not found!

ERROR: v4l2 capture: slave not found!

ERROR: v4l2 capture: slave not found!

ERROR: v4l2 capture: slave not found!

ERROR: v4l2 capture: slave not found!

EXT4-fs (mmcblk0p7): re-mounted. Opts: (null)

warning: `zygote' uses 32-bit capabilities (legacy support in use)

request_suspend_state: wakeup (3->0) at 23445312336 (1970-01-02 00:00:12.815642334 UTC)

cpufreq_interactive_input_connect: connect to max11801_ts

mma enable setting active

eth0: Freescale FEC PHY driver [Generic PHY] (mii_bus:phy_addr=1:01, irq=-1)

ADDRCONF(NETDEV_UP): eth0: link is not ready

acc_open

acc_release

ehci_fsl_bus_resume begins, Host 1

ehci_fsl_bus_resume ends, Host 1

ehci_fsl_bus_resume begins, DR

ehci_fsl_bus_suspend begins, Host 1

ehci_fsl_bus_suspend ends, Host 1

init: sys_prop: permission denied uid:1003  name:service.bootanim.exit

request_suspend_state: sleep (0->3) at 92603837345 (1970-01-02 00:01:21.974165343 UTC)

mma enable setting inactive

PM: Syncing filesystems ... done.

PM: Preparing system for mem sleep

suspend: start 1 suspend...

suspend: finish 1 suspend after:0.2603000 seconds...

Freezing user space processes ... (elapsed 0.01 seconds) done.

Freezing remaining freezable tasks ... (elapsed 0.01 seconds) done.

PM: Entering mem sleep

Suspending console(s) (use no_console_suspend to debug)

USB Host suspend begins

ehci_fsl_drv_suspend, pm event

host suspend ends

udc suspend begins

USB Gadget suspend ends

USB Host suspend begins

ehci_fsl_drv_suspend, pm event

host suspend ends

add wake up source irq 101

add wake up source irq 99

add wake up source irq 103

add wake up source irq 51

PM: suspend of devices complete after 12.320 msecs

PM: late suspend of devices complete after 0.604 msecs

Disabling non-boot CPUs ...

CPU1: shutdown

CPU2: shutdown

CPU3: shutdown

Enabling non-boot CPUs ...

CPU1: Booted secondary processor

Calibrating delay loop (skipped) already calibrated this CPU

i.MXC CPU frequency driver

CPU1 is up

CPU2: Booted secondary processor

Calibrating delay loop (skipped) already calibrated this CPU

i.MXC CPU frequency driver

CPU2 is up

CPU3: Booted secondary processor

Calibrating delay loop (skipped) already calibrated this CPU

i.MXC CPU frequency driver

CPU3 is up

PM: early resume of devices complete after 0.424 msecs

wakeup wake lock: alarm_rtc

imx-ipuv3 imx-ipuv3.0: IPU DMFC DP HIGH RESOLUTION: 1(0,1), 5B(2~5), 5F(6,7)

imx-ipuv3 imx-ipuv3.1: IPU DMFC DP HIGH RESOLUTION: 1(0,1), 5B(2~5), 5F(6,7)

remove wake up source irq 51

remove wake up source irq 103

remove wake up source irq 101

remove wake up source irq 99

ehci fsl drv resume begins: DR

ehci_fsl_drv_resume,pm event, wait for wakeup irq if needed

USB Gadget resume begins

fsl_udc_resume, Wait for wakeup thread finishes

ehci_fsl_bus_resume begins, DR

dr_controller_run: udc enter low power mode

USB Gadget resume ends

ehci fsl drv resume begins: Host 1

ehci_fsl_drv_resume,pm event, wait for wakeup irq if needed

ehci_fsl_bus_resume begins, Host 1

ehci_fsl_bus_resume ends, Host 1

PM: resume of devices complete after 97.620 msecs

PM: Finishing wakeup.

Restarting tasks ... done.

suspend: finish 1 suspend after:3.990689324 seconds...

suspend: exit suspend, ret = 0 (1970-01-02 00:01:26.212731333 UTC)

PM: Syncing filesystems ... done.

PM: Preparing system for mem sleep

suspend: start 2 suspend...

suspend: finish 2 suspend after:0.2603333 seconds...

Freezing user space processes ... (elapsed 0.01 seconds) done.

Freezing remaining freezable tasks ... (elapsed 0.01 seconds) done.

PM: Entering mem sleep

Suspending console(s) (use no_console_suspend to debug)

pm_op(): platform_pm_suspend+0x0/0x5c returns -16

PM: Device alarm failed to suspend: error -16

PM: Some devices failed to suspend

PM: resume of devices complete after 0.546 msecs

PM: Finishing wakeup.

Restarting tasks ... done.

suspend: finish 2 suspend after:0.88187332 seconds...

suspend: exit suspend, ret = -16 (1970-01-02 00:01:27.041896666 UTC)

mmc0: Starting deferred resume

mmc0: Deferred resume completed

PM: Syncing filesystems ... done.

PM: Preparing system for mem sleep

suspend: start 3 suspend...

suspend: finish 3 suspend after:0.2659000 seconds...

Freezing user space processes ... (elapsed 0.02 seconds) done.

Freezing remaining freezable tasks ... (elapsed 0.01 seconds) done.

PM: Entering mem sleep

Suspending console(s) (use no_console_suspend to debug)

。。。。。。

imx6 android gadget,imx6q安卓启动失败显示Suspending console(s)(已解决)相关推荐

  1. win7计算机不支持此接口,win7系统IIS服务器启动失败显示不支持此接口的解决方法...

    很多小伙伴都遇到过 出错表现为以下几点: 1.World Wide Web Publishing 服务在请求配置数据库更改通知时遇到问题.数据域包含错误号. 2.初始化 World Wide Web ...

  2. Ubuntu虚拟机不显示ip地址【已解决】

    Ubuntu虚拟机不显示ip地址[已解决] 安装的Ubuntu虚拟机经常碰到不显示ip地址的情况 如下图: 无法显示ens33的ip地址 解决办法如下: 进入管理员账户,打开终端输入sudo /sbi ...

  3. android R vendor.boot-hal-1-1启动失败问题分析

    记一个android R上开机启动vendor.boot-hal-1-1进程启动失败的过程分析,总结一下下,也给需要的提供个参考. 问题: 在开机启动过程中,一直报错,vendor.boot-hal- ...

  4. 逍遥模拟器显示android,关于逍遥安卓模拟器不显示声音的解决方法,请看官方说明...

    关于逍遥安卓模拟器不显示声音的解决方法,请看官方说明 2020-03-27 有用户反映,使用逍遥安卓模拟器运行游戏过程中突然没有了声音,重新加载之后还是这样,这是为什么呢?针对这一问题,小编整理了具体 ...

  5. 总结—elasticsearch启动失败的几种情况及解决

    1.使用root用户启动失败 在有一次搭建elasticsearch的时候,使用systemctl启动elasticsearch失败,然后在bin目录下面去使用启动脚本启动,发现报错不能用root用户 ...

  6. 【elasticsearch】总结—elasticsearch启动失败的几种情况及解决

    1.使用root用户启动失败 在有一次搭建elasticsearch的时候,使用systemctl启动elasticsearch失败,然后在bin目录下面去使用启动脚本启动,发现报错不能用root用户 ...

  7. windows10服务器运行失败,win10遇到服务器启动失败 80端口被占用如何解决

    Win10提示"服务器启动失败,80端口被占用"怎么办?具体解决方法如下 步骤如下: 1.以管理员身份运行cmd; 2.输入:net stop http 注:如果提示是否真的需要停 ...

  8. 安装java后电脑崩溃了_我的世界游戏启动失败怎么办 PC版游戏崩溃解决办法

    MC在使用的过程中经常会出现游戏启动失败,或者游戏崩溃的情况,遇到这些情况要怎么办呢?今天PConline为大家带来 我的世界电脑版 游戏启动失败怎么办,PC版游戏崩溃解决办法,解决大家的烦恼! 游戏 ...

  9. neutron-server.service启动失败显示代理报错http://controller:9696/v2.0/agents.json

    启动neutron-server.service服务不成功,在显示代理中报错connection to http://controller:9696/v2.0/agents.json [root@co ...

  10. hive启动失败 显示:Caused by: com.mysql.cj.exceptions.InvalidConnectionAttributeException: The server time

    标题[报错]Caused by: com.mysql.cj.exceptions.InvalidConnectionAttributeException: The server time zone v ...

最新文章

  1. redis消息队列写入mysql_redis怎么实现将消息队列持久化到数据库中?
  2. git提交代码遇到fatal: unable to access
  3. 衡量计算机的平均无故障时间6,平均无故障时间MTBF测试及计算过程
  4. Python中数据类型的操作
  5. mediastreamer2 的简介
  6. 企业实战(Jenkins+GitLab+SonarQube)_05_Jenkins创建管理员用户
  7. Oracle 20c 新特性:XGBoost 机器学习算法和 AutoML 的支持
  8. 谈谈HtmlControl与WebControl的区别与用途
  9. 控制台 钢铁雄心2_钢铁雄心4控制台 (2)
  10. MATLAB平台文字识别算法实现
  11. 服务器08系统操作日志在哪看,怎么查看服务器操作系统日志
  12. ux设计_我是一名开发人员,正在过渡到UX设计帮助
  13. 在校园网中进行无线路由器设置
  14. WIN10电脑热点无法共享
  15. android qmui教程,QMUI-Android
  16. linux重装出现cannot load file 5555h,在安装系统出现error cannot load file code 5555h 的解决办法...
  17. 数据开发岗面试绝地求生
  18. HTML5和CSS3核心笔记
  19. l开头的英文车标是什么车_l开头的车标一串英文(车标里面带个大写L,看外观是辆跑车,是什么牌子啊,不是雷克萨斯?)...
  20. 软件验收测试是什么,验收测试报告怎么做

热门文章

  1. 《下终南山过斛斯山人宿置酒》 作者:李白
  2. ie不支持includes_IE11 – 对象不支持属性或方法“includes” – javascript window.location.hash...
  3. 2021年最新3d材质贴图素材大合集来咯
  4. 计算机课听课评语和建议,听课记录的评语及建议
  5. CSS基础教程17篇 [翻译Htmldog]
  6. 如何正确的使用国产杀毒软件
  7. 【Java基础】· 面向对象编程(下)习题详解
  8. 惠州学院计算机学院陈东骏,教学情况简报第107期
  9. 分类问题——逻辑回归与XGBoost
  10. Oracle minus用法详解及应用实例